Components and Parts Idea/Ad Exchange, free for members. > Southwest
> New millermatic 140 with cart -115V mig welder-
New millermatic 140 with cart -115V mig welder-
MILLERMATIC 140-907311with Miller Cart - 194776All-in-one wire welding package welds 24 gauge - 3/16 in (0.8 - 4.8 mm) mild steel.
For your safety, our built-in contactor makes wire electrically "cold" when not welding
Contact tip life is extended by the exclusive Miller short-circuit protection which easily resets with the release of the gun trigger.
Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted.
Short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger reset permits quick reset at torch.
* Flux Cored (FCAW) (gas and self-shielded)
* 90 A at 18 VDC, 20% Duty Cycle
* 10 ft (3 m), M-10 MIG gun and cable assembly with liner for .024 - .035 in (0.6-0.9 mm) wire
* 10 ft (3 m) work cable and clamp
* Argon and AR/CO2 mix regulator/flow gauge with hose
* Sample spool of .024 in (0.6 mm) solid wire
* Two contact tips for .024 in (0.6 mm) wire and two contact tips for .030 in (0.8 mm) wire
* Dual groove drive roll for .024 in (0.6 mm) or .030/.035 in (0.8/0.9 mm) wire
* Factory-installed contactor and gas solenoid valve
* Information/settings chart
Infinite voltage control with wire feed speed tracking provides broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted.
Durable cast aluminum feedhead incorporates dual groove quick-change drive roll and calibrated, spring-loaded tension arm designed to make setup easier and faster.
Easy access to output studs provides convenient polarity changeover when switching from solid or flux cored wires.
Built-in solid-state contactor circuit makes wire electrically "cold" until trigger is pulled. Makes unit safer, and is easier to position torch to work before starting weld.
Thermal overload protection shuts down the unit and activates over temperature light if airflow is blocked or duty cycle is exceeded. Automatically resets when fault is corrected and unit cools.
